7. Place the gasket on the cover. Use clamp bolts to install the cover on the valve body. See Figure 4-40. 10. Install all detent blocks on this side of the valve. See Figure 4-43. Insert the detent blocks so that their O-rings are inside the valve bore. FIGURE 4-40 4479 FIGURE 4-43 4482 8. Install the spool and spring as shown in Figure 4-41. 11. Install all solenoids on this side of the valve. See Figure 4-44. Install the bolts that hold the solenoids in place. Tighten the bolts to 6 Nm (4.4 ft lb). FIGURE 4-41 4480 9. Install the spool and spring as shown in Figure 4-42. Install all spools and springs on this side of the valve block.
FIGURE 4-44 4483 FIGURE 4-42 4481 4-16 TORQUE CONVERTER AND TRANSMISSION Mega 300-III Shop Manual