12. Thread the wire harness through the opening in the valve body. Install the harness socket in the opening. See Figure 4-45. Bolt the socket in place. 15. Install the spool and spring in the side of the control valve block. See Figure 4-48. Install the pin to limit the movement of the spool. FIGURE 4-45 4484 FIGURE 4-48 4487 16. Place a gasket on the control valve block. Insert a second control pin into the control valve block. See Figure 4-49. Slide the control valve block up to the valve body by using the control pin. 13. Install the wires on the solenoids. See Figure 4-46. Secure the ground wire in place. FIGURE 4-46 4485 14. Install the O-ring inside the solenoid cover.
Install the cover on the valve body. See Figure 4-47. Use the spring clip to hold the cover in place. FIGURE 4-49 4488 FIGURE 4-47 4486 Mega 300-III Shop Manual TORQUE CONVERTER AND TRANSMISSION 4-17