daewoo — Daewoo Wheel Loader Shop Manual

17. Place a gasket on the control valve. Install the piston and spring into the control valve. See Figure 4-50. Install the control valve onto the valve block. Transmission WG-180 Control Valve Disassembly 1. This procedure describes disassembly and assembly of the control valve on the WG-180 transmission. See Figure 4-52. FIGURE 4-50 4489 18. Install the bolts into the control valve and tighten to 6 Nm (4.4 ft lb). See Figure 4-51. FIGURE 4-52 4491 2. Remove 2 bolts, one from each corner of the upper control valve. See Figure 4-53. Install a locating stud in place of each bolt. Remove all bolts that hold the control valve to the trans- mission.

Remove the control valve from the transmission. FIGURE 4-51 4490 FIGURE 4-53 4492 4-18 TORQUE CONVERTER AND TRANSMISSION Mega 300-III Shop Manual