Assembly 1. Figure 4-60 displays the spools, springs, detent blocks, and solenoids that are installed in the valve. lb). 4. Install the springs, spools, stop blocks, and solenoids into the solenoid side of the control FIGURE 4-63 4502 FIGURE 4-60 4499 2. Install the detent blocks and the stop plates into the valve body. See Figure 4-61. Install the springs and spools into the valve bores on the non solenoid side of the valve. valve. See Figure 4-63. Bolt the solenoids to the valve body. FIGURE 4-64 4503 FIGURE 4-61 4500 5. Attach the wires to the solenoids. See Figure 4-64. 3. Install a gasket on the cover. Install the bolts that hold the cover to the valve body. See Figure 4-62.
Tighten the bolts to 6 Nm (4.4 ft 6. Install an O-ring into the solenoid cover. FIGURE 4-65 4504 FIGURE 4-62 4501 4-20 TORQUE CONVERTER AND TRANSMISSION Mega 300-III Shop Manual