OPERATION Remark When operating the manual reverse switch, hold the switch at position (b) for at least 0.5 seconds, then release it. When the fan rotation direction is switched, the reverse rotation pilot lamp flashes. To protect the machine, the fan rotation direction cannot change when the fan is operating under high load or in low temperatures. For details, see “Conditions for Switching Fan Rotation” on page 2-46. When the engine is stopped, the fan rotation direction returns to the normal direction. If the switch is set to position (b) (manual reverse rotation ON), the switch returns to position (c) (Neutral) when the switch is released.
Even if position (b) of the switch is not kept pressed, the fan will rotate in the reverse direction for a fixed time. It is not necessary to keep the switch pressed at position (b). During reverse rotation of the fan, if the engine cooling water, boost, or HST oil overheat (the oil temperature caution lamp on the machine monitor illuminates), the reverse rotation of the fan is forcibly stopped, and the fan switches to rotation in the normal direction. It is possible to adjust the following automatic reverse rotation functions: Cycle fan automatic reverse rotation (Standard: 2 hours) Continuous time fan automatic reverse rotation (Standard:
2 minutes) Please ask your Komatsu distributor to carry out the adjustment Conditions for Switching Fan Rotation You can switch from normal rotation to reverse rotation manually or automatically. Using Manual Reverse Rotation Function You can switch from normal rotation to reverse rotation and from reverse rotation to normal rotation. Switching from Normal Rotation to Reverse Rotation The fan will switch from normal rotation to reverse rotation only if all the following conditions are fulfilled. If all the conditions are not fulfilled, the fan direction will not change. Conditions: Portion (b) of the cooling fan automatic reverse rotation switch is pressed once.
The engine speed is between Lo and 1,200 rpm. If the HST oil temperature is above 30°C (86°F), the engine speed condition does not apply. The engine water temperature is less than 102°C (215.6°F). The HST oil temperature is less than 100°C (212°F). At least 30 seconds have passed since the engine was started. If the direction is switched, the cooling fan reverse rotation pilot lamp on the machine monitor will change from flashing and will remain illuminated. If the direction is not switched, the cooling fan reverse rotation pilot lamp on the machine monitor will continue to flash. 2-46 WA250-6