Komatsu — GUIDE TO MAINTENANCE

. MAINTENANCE GUIDE TO MAINTENANCE into the oil. AVOID MIXING OILS: 4 - 3 When inspecting or changing the o il, move the machine to a place that is free of dus t to preve nt dirt from getting If a different brand or grade of oil has t o be added, drain the old oil and replace all the oil with the n ew brand o r grade of oil. Never mix different brand or gr LOCKING THE INSPECTION COVER: position with the lock bar. If inspection or maintenance is performed with Lock inspection cover securely into with inspection cover not locked in positio n, there is a danger that it may be suddenly blow shu t by th e win d an d cause injury to the worker. HYDRAULIC SYSTEM - AIR BLEEDIN G:

After repairing or replacing hydraulic equipment or removing hydraulic piping, it is necessary to bleed the air f rom inside the circuit. For details of the procedure for bleeding air, see "METHOD FOR RELEASING INTERNAL IT (PAGE 4-64)". ELEASING INTERNAL PRESSURE IN HYDRAULIC CIRCU HYDRAULIC HOSE INSTALLATION: When removing places fitted with O-rings, gaskets, or other seals, clean the mounting s urface and replace with a new part. When doing this, do not forget to i nstall the O-rings and gaskets. When installing the hoses, do not twist them or bend them sharply. If they are installed so, th eir service life will be shortened extremely and they may be damaged.

CHECK AFTER INSPECTION AND MA INTENANCE WORKS: If you forget to perform the checks a fter inspection and maintenance, unexpected problems m ay occur, and this may lead to serious injury or propert y damage. Always do the following: e stopped) enance points been forgotten? nance items been performed correctly? Checks after operation (with engin Have any inspection and maint Have all inspection and mainte Have any tools or parts been d inside the machine and get cau Are there any leakage of coola ropped inside the machine? It is particularly dangerous if parts are d ropped ght in the lever linkage mechanism. nt or oil? Have all nuts and bolts been tightened? nt or oil?

Have all nuts and bolts been tightened? Checks when operating engine For details of the checks when attention to safety. Are the inspection and mainten Is there any leakage of fuel or operating the engine, see "PROPER TOOLS (PAGE 2-37 )" and pay careful ance items working properly? oil when the engine speed is raised? SELECTING FUEL AND LUBRICANTS TO MATCH AMBIENT TEMPERATURE: ants that match the ambient temperature. It is necessary to use fuel and lubric For details, see "RECOMMENDED FUEL, COOLANT AND LUBRICANTS (PAGE 4-13)"