Komatsu — 6.4.1 DESCRIPTION

PALLET FORKS 6.4 PALLET FORKS IMPORTANT q (For the characteristics, see table "6.1.3 CHARACTERISTICS OF THE OPTIONAL EQUIPMENT"). q Before lifting the load, make sure that the position of its centre (G) complies with the distances indicated in the figure below. Furthermore, the load must always be centered with respect to the forks. Non- compliance with these rules may cause serious damage and even death. q Before handling any load, verify the capacity of the forks. The allowed load is generally stamped on the forks.

Max 500 mm Max 500 mm G F RWA38740 6.4.1 DESCRIPTION They are usually applied to the 4in1 bucket and when they are not used they must be overturned towards the back of the machine and secured with the safety pins provided. The pallet forks (1) make it possible to use the machine as a normal lift truck and the controls to lift and oscillate them are the same used to control the standard bucket (see "3.3.6 pos. 4 - FRONT LOADER CONTROL LEVER"). The distance between the pallet forks can be varied to adapt them to the load to be handled; to do this, make them slide on the coupling bar (2). 2 1 RKA15490 252 DANGER