PALLET FORKS 6.4.3.1 PREPARING THE PALLET FORKS FOR USE 1 - Overturn the forks toward the front part of the machine. 2 - Lift the bucket and operate the control lever in such a way as to swing it forward until releasing the forks from the bucket teeth. 3 - Move the forks (1) sidewards to widen or narrow the distance between them according to the width of the load to be handled. 4 - Fold the bucket and manoeuvre the lifting arm until the forks are in horizontal position. 5 - Lubricate the fork rotation pins (see "4.5.2 LUBRICATION DIAGRAM (4in1 bucket and pallet forks)"). 6.4.3.2 OVERTURNING THE FORKS 1 - Remove the safety pins (4) and the pins (3).
2 - When at rest, the forks may be arranged in two different positions, and precisely: A 4 4 FOR TRAVEL ON ROADS (Only for machines with approval for travel on roads): make the forks slide towards the centre of the bucket, overturn them and insert them in the supports (5) as shown in Figure A. It is also compulsory to install the locks as described in paragraph "3.1 SAFETY LOCKS". 5 3 5 3 DURING WORK: make the forks slide towards the outside of the bucket, overturn them and insert them in the supports (5) as shown in Fig. B. RWA34560 B q During work, avoid keeping the forks as represented in Figure A, since they may make contact with the engine hood.
3 - Put back the pins (3) and the safety pins (4). 4 - Make sure that when they are overturned in rest position the forks are firmly secured inside their respective supports (5). If any slack should be observed between the forks and the safety pin (3), immediately carry out the necessary adjustment. The correct adjusting procedure is as follows: - Release the stop nut (10) and loosen the adjusting screw (11) until taking up the slack between the fork and the safety pin (3). Use a 22 mm hex wrench. - After the adjustment, tighten the stop nut (10) thoroughly. If the adjusting screw (11) should be excessively worn, do not hesitate to replace it.
4 5 RWA39680 3 q The check and adjustment of the forks must be carried out on both sides, with the forks at rest. Do not hesitate to adjust the forks as soon as the presence of a slack is noticed. Non-compliance with these instructions may lead to dangerous situations for the operator and cause serious damage to the machine. 10 11 q Before carrying out any movement with the machine, make sure that the safety pins (4) are correctly inserted. RWAB0680 254 CAUTION CAUTION