PALLET FORKS 6.4.4 REMOVING THE FORKS q Pay the utmost attention when removing the forks, the supports and the bar, in order not to crush or even cut off your hands or feet. 1 - Manoeuvre the lifting arm and swing the bucket until resting the forks (1) on the ground in horizontal position. 2 - Remove the safety pins (6) and the pins (7). If also the supports (8) must be removed: 3 - Loosen and remove the screws (9) that fasten the slide bar (2). 4 - Hold one of the supports (8) and withdraw the slide bar (2); repeat the same operation for the other support.
RKA15520 A 9 2 A 8 8 B B 7 1 6 6.4.5 INSTALLING THE FORKS To install the pallet forks, repeat the procedure described for the removal in the reverse order, taking the same precautions. 6.4.6 MAINTENANCE No specific maintenance operation is required for this device, except for the occasional greasing of the slide bar and of the fork fulcrum pin (see "4.5.2 LUBRICATION DIAGRAM (4in1 bucket and pallet forks)"). 255 WARNING