BACKHOE TELESCOPIC ARM 6.5.4 MAINTENANCE The telescopic arm requires two maintenance operations: 1 - Lubrication of the joints (see "4.5.1 LUBRICATION DIAGRAM"). 2 - Adjustment of the slide guide (8) slack, which must be carried out occasionally, when impacts or vibrations are noticed during work. 6.5.4.1 ADJUSTING THE GUIDE SLACK q When leaving the operator’s seat during the adjustment of the guides, remove the ignition key. q Adjust the screws and guides one by one. 9 q Do not place tools in the space between the safety locks and the arm. 1 - Position the machine on flat ground and lower the stabilizers.
2 - Lift the boom, fold the bucket completely and extend the telescopic part (7) completely. 7 3 - Fold the arm until the slide guides (8) are perpendicular to the ground and in any case positioned so that the extending part is completely free and does not overload the guides. 8 4 - Stop the engine. 5 - Check the side on which the adjusting dowels (9) of the guides protrude more. Adjust by working on this side only. RKA14390 258 WARNING