BACKHOE TELESCOPIC ARM q If the adjusting dowels (9) protrude to the same extent on the two sides, the operation described at point 6 can be carried out either on the right or on the left side. 5 mm 6 - Loosen the four lock nuts (10) and tighten the adjusting dowels (9) thoroughly, until taking up the slack completely. (Use a 27 mm wrench and a 8 mm hex wrench). 7 - Starting from the central positions, loosen the adjusting dowels (9) by 270° (3/4 turn) and lock them with the lock nuts (10). RWA04050 Shoe to be changed 8 - Start the machine, extend and retract the telescopic arm more than once to make sure that it slides correctly.
q The wear limit allowed for the rubber blocks is represented by the minimum engagement of the adjusting dowels (9) in the lock nuts; the rubber blocks must be replaced when the heads of the dowels (9) are 5 mm back with respect to the lock nuts (10). 10 9 q When taking up the slack, avoid excessive pressures, in order to prevent the guides from seizing. Reducing clearance RWA03950 10 9 270 ° Clearance = 0 RWA03850 " 259 CAUTION CAUTION