Komatsu — 6.9.2 INSTALLING THE CLAMSHELL BUCKET

CONFIGURATION FOR THE USE OF THE CLAMSHELL BUCKET 6.9.2 INSTALLING THE CLAMSHELL BUCKET q The machine must be parked on a level surface, with the front equipment resting on the ground. q When the coupling pins are removed or installed, chips may come off; always use gloves, goggles and helmet. q The change of the equipment must be carried out by two operators, who must decide together the words and signals to be used during work. q Avoid using your fingers to align the holes, since they may be injured or even cut off. q Completely release the residual pressure that may be present in the pipes. To install the revolving clamshell bucket, proceed as follows:

1 - Remove the standard bucket from the backhoe (see "3.13.4.1 CHANGING THE BACKHOE BUCKET"). 2 - Retract the bucket control piston completely. 3 - Connect the clamshell bucket to the arm. 4 - Stop the machine and move the controls in all directions to release the residual pressure. IMPORTANT q If the machine is equipped with backhoe servo controls, to eliminate the residual pressure proceed as follows: 1 - With the engine at rest, turn the ignition key to position « » . 2 - Press the servo control locking button and make sure that the LED is off (release position) (see "3.3.2 pos. 12 - SERVO CONTROL LOCKING BUTTON").

3 - Shift the backhoe control levers more than once and press the clamshell bucket swing buttons. 4 - Turn the ignition key to position « » . 5 - Mechanically lock the standard bucket thrust lever, in such a way as to lock the piston at the end of stroke. RWA01960 RWA02000 274 WARNING