CONFIGURATION FOR THE USE OF THE CLAMSHELL BUCKET q During the following steps, take care to prevent any impurities from getting into the pipes and the cylinder. q If any oil has been spilled, wipe it up immediately, in order to prevent the surface from getting slippery. FOR STANDARD ARM (FIG. A) 6 - Disconnect the pipes (2-3) that operate the piston from the bucket cylinder (1) and seal the cylinder couplings (4). FOR TELESCOPIC ARM (FIG. B) 6 - Disconnect the pipes (2-3) that operate the piston from the bucket cylinder (1) and seal the cylinder couplings (4). 7 - Connect the pipes disconnected from the cylinder to the couplings for the opening and folding of the clamshell bucket.
8 - Remove the plugs from the rigid pipes of the system and connect the pipes. 9 - Start the machine and lift the clamshell bucket a few centrimetres from the ground. 10 - Open, fold and swing the bucket several times, in order to check the tightness of the system. q Wear thick gloves and safety goggles during this check. q To check the system for leaks, use a piece of cardboard or a wooden board. 6.9.3 USING THE CLAMSHELL BUCKET Consult the specific operation manual. 6.9.4 MAINTENANCE The hydraulic system does not require any maintenance operation and inspection other than those prescribed for the machine.
Regarding the maintenance operations required for the clamshell bucket, see the specific operation manual. 275 CAUTION WARNING