Komatsu — 6.12.1 EQUIPMENT COUPLING AND RELEASE PROCEDURE

REAR EQUIPMENT MECHANICAL QUICK COUPLING DEVICE 6.12.1 EQUIPMENT COUPLING AND RELEASE PROCEDURE RWA38570 1 6 q When the coupling pins are removed or installed, chips may come off; always use gloves, goggles and helmet. 3 5 q The change of the equipment must be carried out by two operators, who must decide together the words and signals to be used during work. 2 4 q Avoid using your fingers to align the holes, since the may 4 be injured or even cut off. The following description illustrates by way of example the coupling and release procedure of a standard digging bucket. After installing the quick coupling device (1) on the backhoe arm, proceed as indicated below. 1 2 q Coupling procedure:

1- Position the bucket on the ground, taking care to choose a level surface and directing the bucket so that its flat part rests on the ground. RWAB0530 2 - Insert the pins (2) and (3), in this order, in the apposite coupling holes in the bucket. Lock the pins (2) and (3) with the relevant safety retainers (4). Clean the pins (2), (3) and the bushings carefully before inserting them in the bucket and, if necessary, grease them slightly. 1 2 3 - Remove the safety pin (5) with the relevant retainer (6) from the quick coupling (1). 4 - Move the arm near the bucket and with a simple folding movement engage the front pin (2) with the quick coupling (1).

5 - Slightly lift the bucket, making sure that it is perfectly coupled with the pin (2). RWAB0540 6 - Engage the coupling pin (3) with the quick coupling (1), using the bucket folding hydraulic movement. Once the bucket has been coupled, make sure that it is perfectly engaged and insert the safety pin (5) in the apposite hole in the quick coupling (1). Fit the retainer (6) in its place. IMPORTANT 1 q The engagement of the bucket in the quick coupling must always take place first with the pin (2) and successively with the pin (3). RWAB0550 3 q Before starting work the operator must make sure that the bucket is correctly connected to the quick coupling. 281 WARNING CAUTION CAUTION