Perkins — Perkins Sabre Marine Engines Installation Manual

TPD1317e Chapter 11 Page 69 Model M300Ti Model M265Ti Minimum cross section of air duct (per engine) 910cm2(142sq ins) for hot climates 806cm2(126sq ins) for hot climates 455cm2(71sq ins) for temperate 406cm2(63sq ins) for temperate climates climates Exhaust Exhaust gas flow 43.1m3 /min (1520ft3/min) 36.4m3 /min (1290ft3/min) Maximum restriction measured 10.2kPa (3.0”Hg) within (305mm) 12” of turbocharger outlet Recommended pipe bore (wet 127mm (5.0”) exhaust) Recommended pipe bore (dry) 76.2mm (3.0”) Minimum rise from sea level to 203mm (8.0”) exhaust outlet centre-line Lubricating System Recommended lubricating oil API CF-4/SE or CCMC D5 Sump capacity maximum 15 litres (3.3 gallons) Maximum installation angle 17o engine front up plus 3o rise plus planing angle for 5o nose down plus 3o rise, with special kit of parts.

continuous operation 30o heel when motor sailing Oil pressure in operating 2.5 to 3.5 bar (36 to 50 psi) speed range (steady state) Low oil pressure switch setting 0.8 bar (12 psi) Electrical System Alternator Lucas A127 40 amp (24 volt) or 70 amp (12 volt) Starter type Lucas S115 Number of teeth in flywheel 126 Number of teeth on starter 10 Cold Start Limits Minimum cold start temperature -15oC (5oF) (with aid) Batteries for minimum 2 off 12 volt - each 520 amps to BS 3911 cold start or 2 off 12 volt - each 800 amps to SAE J537