TPD1317e Chapter 11 11.3 M135, and M130C Engines Page 73 Model M135 Model M130C Basic Technical Data Rated power 130 PS (96 kW) Rated engine speed 2600 rev/min Number of cylinders 6 Cylinder arrangement In-line Cycle 4 stroke lnduction system Naturally aspirated Bore 100 mm (3.937”) Stroke 127 mm (5.00”) Compression ratio 16.5:1 Cubic capacity 6.00 litres (365 in3) Valves per cylinder 2 Direction of rotation Anti-clockwise viewed on flywheel Firing order 1, 5, 3, 6, 2, 4 Total weight (wet) 595 kg (1312 lb) engine only including starter and alternator. Cooling System The coolant shown below is mandatory for use in all climates to ensure that adequate levels of corrosion inhibitor are present.
It will give frost protection to -37oC. Coolant 50% inhibited ethylene glycol or 50% inhibited propylene glycol with 50% fresh clean water Fresh water flow 213 litre/min (47 gall/min) at 2600 rev/min Coolant pump speed and method of drive. 1:1 Gear driven System capacity 25.3 litres (5.6 gallons) Pressure cap setting 48 kPa (7 psi) Protection switch setting 96oC Sea water pump type Jabsco gear driven model 25.4 mm (1”) full cam. Sea water suggested inlet hose diameter. 32 mm (1.25”) Sea cock Full flow 25.4mm (1.00”) Strainer A raw water strainer must be included in the suction side of the circuit.