Perkins — Perkins Sabre Marine Engines Installation Manual

TPD1317e Chapter 11 Page 75 Model M135 Model M130C Exhaust Exhaust gas flow 20 m3/min (706 ft3/min). Maximum restriction measured within(305 mm) 12” of turbocharger outlet. 10.2 kPa (3.0” Hg) Recommended pipe bore (wet exhaust). 76 mm (3.0”) Recommended pipe bore (dry). 63.5 mm (2.5”) Minimum rise from sea water level to exhaust outlet centreline. 203 mm (8.0”) Lubricating System Recommended lubricating oil. AP1 CC/SE API CD/SE or CCMC D4 can also be used but are not recommended for first 20/40 hours Sump capacity maximum 15 litres (3.3 gallons) Maximum installation angle plus planing angle for continuous operation. 17o engine front up + 3o rise.

5o nose down + 3o rise with special kit of parts, 30o heel Oil pressure, in operating speed range (steady state). 280 kN/m2 (40 psi) Low oil pressure switch setting. 83 kN/m2 (12 psi) Electrical System Alternator Lucas A127 40A (24V) or 70A (12V). Starter type CAV CA45H Number of teeth in flywheel 126 Number of teeth on starter 10 Cold Start Limits Minimum cold start temperature (with aid). -15oC (5oF) Batteries for minimum 2 off - 315 Amps to BS3911 or cold start 2 off - 535 Amps to SAE J537