3.3 Operation Operation Adjusting mirrors Be sure to adjust the mirrors before starting work. If they are not adjusted properly, you cannot secure the visibility and may be injured or may injure someone seriously. Mirrors A, B Loosen bolt (1) of the mirror, then adjust the mirror to a position which gives the best view from the operator's seat of the blind spot at the left and right sides at the rear of the machine. 1 When installing the mirror, adjust so that it is possible to see any person (or any object of a height of 1 m and diameter of 30 cm) at the rear left or right of the machine.
GK038077 Mirrors C Adjust so that is possible to see the ground around the machine at a range of 1 m from the operator's seat. 2 If the movement of the mirror is stiff when adjusting it, loosen bolt (2) of the mirror. GK038078 Install the mirrors at the position and dimensions shown in the diagram. The values below are reference values for the range of visibility. B (B) Range of view (left): 3400 mm Range of view (right): 3400 mm (A) Mirror A: Must be possible to see hatched portion (A) Mirror B: Must be possible to see hatched portion (B) A Mirror C: Must be possible to see hatched portion (C) C NOTE !
Tighten the mirror mounting bolts securely that they will not be loosened and the mirrors will not come off. (B) (C) ! Tightening torque Mirrors A, B: 2.0 to 2.5 Nm Mirrors C: 8.8 to 9.8 Nm GK047017 ! If the tightening torque cannot be controlled, ask your KOMATSU distributor for tightening the bolts. 3-102 WA470-6H – VEAM946100 WARNING WARNING