Operation 3.3 Operation Starting in cold weather ! Start the engine only after sitting down in the operator's seat. ! Do not attempt to start the engine by short-circuiting the engine starting circuit. Such an act may cause serious bodily injury or fire. ! Check that there are no persons or obstacles in the sur- rounding area, then sound the horn and start the engine. ! Exhaust gas is toxic. When starting the engine in confined spaces, be particularly careful to ensure good ventilation. GK038080 1 NOTE ! Do not accelerate the engine suddenly before completing the warming-up operation. ! Do not start the engine with the accelerator pedal fully depressed.
There is danger that the engine parts may be damaged. When starting the engine after the machine has been left for more than half a day in temperatures near -20°C, it will take time for the engine to achieve complete combustion, so operate the starting switch as follows. GK038005 2 1. Turn the key in starting switch (1) to ON position (B). If the ambient temperature is low, the preheating pilot lamp (2) lights up and automatic preheating is carried out. Keep the key in starting switch (1) at the ON position until the pre- heating pilot lamp (2) goes out.
A B C GK038021 The time that the preheating pilot lamp (2) stays lighted up depends on the ambient temperature as shown in the table on the right. Ambient temperature Lighting time -1°C to -15°C 0 seconds to 30 seconds -15°C or less 30 seconds WA470-6H – VEAM946100 3-107 WARNING WARNING