Komatsu — Digging operations

3.3 Operation Operation 3.3.9 Work possible using wheel loader In addition to the following, it is possible to further increase the range of applications by using various attachments. Digging operations ! Never carry out digging or scooping operations with the machine articulated. There is danger that the machine may tip over. ! Never raise the boom with the bucket fully loaded when the machine is articulated. There is danger that the machine may tip over. ! When the machine is traveling or the work equipment is raised, the moment that the E.C.S.S. switch is turned ON, the work equipment will move. !

If operations are carried out with the E.C.S.S.switch left at the ON position, the moment that the travel damper is actu- ated, the work equipment will move. NOTE If the tires slip, the tire life will be reduced, so do not allow the tires to slip during operation. Loading piled soil or blasted rock When loading piled soil or blasted rock,drive the machine for- ward as follows to load. To prevent cutting of the tires caused by the tires slipping, be careful of the following points during the operation. Always keep the operating jobsite flat, and remove any fallen rocks.

When working with stockpiles, operate the machine in 1st or 2nd gear; when loading blasted rock operate the machine in 1st gear. 1. When driving the machine forward and lowering the bucket, stop the bucket at height (A) approx. 30 cm (12 in) from the ground, then lower it slowly. REMARK If the bucket hits the ground, the front tires will come off the ground, and the tires will slip. A 2. Shift down immediately in front of the material to be loaded. When completing the shift down, depress the accelerator pedal at the same time and thrust the bucket into the mate- rial. GK043180 3-130 WA470-6H – VEAM946100 WARNING WARNING