Komatsu — 3.7.2 Towing the machine

Operation 3.7 Troubleshooting NOTE ! Towing is for moving the machine to a place where inspec- tion and maintenance can be carried out, and not for moving it long distances. The machine must not be towed for long distances. ! For details of the procedure for towing a machine when it has broken down, please contact your KOMATSU distribu- tor. This machine must not be towed except in emergencies. When towing the machine, take the following precautions. ! Before releasing the brakes, put blocks under the wheels to prevent the machine from moving. If the wheels are not blocked, the machine may suddenly move. !

When towing a machine, tow it at a low speed of less than 2 km/h (1.2 MPH), and for a distance of a few meters to a place where repairs can be carried out. The machine should be towed only in emergencies. If the machine must be moved long distances, use a transporter. ! To protect the operator if the towing rope or bar should break, install a protector plate to the machine being towed. ! If it is impossible to operate the steering and brakes of the machine being towed, do not let anyone ride on the machine. ! Check that the tow rope or bar is of ample strength for the weight of the machine being towed.

If the machine being towed must travel through mud or up hills, use a tow rope or bar of a strength of at least 1.5 times the weight of the machine being towed. ! Keep the angle of the tow rope as small as possible. Keep the angle between the center lines of the two machines to within 30 degrees. ! If the machine is moved suddenly, the tow rope or bar will be subjected to an excessive load, and it may break. Start the machine gradually and travel at a constant speed. ! The towing machine should normally be of the same class as the machine being towed. Check that the towing machine has ample braking power, weight, and rimpull to allow it to control both machines on slopes or on the tow road.

WA470-6H – VEAM946100 3-163