4.9 Service procedure When required Maintenance Even in the areas where freezing is not an issue, the use of anti- freeze coolant is essential. KOMATSU machines are supplied with KOMATSU Supercoolant (AF-NAC). KOMATSU Supercoolant (AF-NAC) has excellent anticorrosion, antifreeze and cooling properties and can be used continuously for 2 years or 4000 hours. KOMATSU Supercoolant (AF-NAC) is strongly recommended wherever available. To maintain the anticorrosion properties of Supercoolant (AF- NAC), always keep the density of Supercoolant between 30% and 68%. When using KOMATSU Supercoolant (AF-NAC), there is no need to use a corrosion resistor.
When no corrosion resistor is used, use the special cover (600- 411-9000). Please consult your KOMATSU distributor about the method of installing. When deciding the ratio of antifreeze to water, check the lowest temperature in the past, and decide from the mixing table given below. It is actually better to estimate a temperature about 10°C lower when deciding the mixing rate. The mixing ratio depends on the ambient temperature, but it should always be a minimum of 30% by volume (antifreeze/total amount of coolant x 100). The freezing temperature of undiluted antifreeze is -15°C. Do not store undiluted antifreeze at a temperature of below -15°C.
Mixing rate of water and antifreeze 4-36 WA470-6H – VEAM946100 Min. atmospheric temperature °C -10 -15 -20 -25 -30 °F 14 5 -4 -13 -22 Amount of antifreeze Liter 18.3 21.4 24.4 27.5 30.5 US gal 4.83 5.64 6.44 7.25 8.06 Amount of water Liter 42.7 39.7 36.6 33.6 30.5 US gal 11.28 10.47 9.67 8.86 8.06 Ratio % 30 35 40 45 50