John Deere Radial Piston Pumps (3000 Series) — John Deere Radial Piston Pumps (3000 Series) User Manual

AW1 ;RW1b73 b R70; 070300 1199 170589 AW1;RW1b73 7 R70; 070300 1200 150589 t AW1;RW1b73 8 R70; 070300 1201 170589 CTM -7 (5-89) 2R3; 015 16 11058~ 3000 Series (HPR)-Hydraulic Pump For "8" DRIVE COUPLER, perform Steps 5a, 5b, 5c, 5d, 5e, Sf, and 5g. 5a. Inspect coupler splines (A) for excessive wear or damage. IMPORTANT: Do not remove coupler from shaft unless absolutely necessary. Coupler will have to be removed in order to remove rear bearing cone on pump shaft and rear bearing race assembly on double bank pump shaft. NOTE: Machine screws should be ground on the ends so shaft length of screws are 7.9 mm (5/16 in.) long. This is important when compressing snap ring during coupler removal.

5b. Insert a No.2 or NO.3 machine screw 3/8 in. long into each of the five holes (8) in coupler. Check for snap ring spring-back by pushing on screw while pushing coupler toward bearing. Snap ring must be under all five holes before coupler can be removed. Skip Step 5c and 5d if snap ring is under all five holes. 5d. Put screws in holes (2) and (4) and use the following push-release sequence to make snap ring "walk around" internal groove: Continue sequence until snap ring is under all five holes in coupler. 5e. Compress snap ring in coupler by installing No.2 or No.3 machine screws in each of the five holes in coupler.

Use a piece of metal strapping material and a hose clamp to compress snap ring. 5f. Pry coupler off end of shaft while snap ring is compressed. 5g . Inspect internal splines of coupler for excessive wear or damage. Replace snap ring as required. Litho in U.S.A. 15·16 5c. Mark hole (1) where snap is not present. B-Release 2 Release 4 A-Push 2 Push 4 AllTractorManuals.com