CTM-7 (5-89) 2R) ; 010 1) 11058. AW1;R39702 R70;070300 1111 010388 AW1 ;R39703 R70 ;070300 1061 010388 2000 Series (PR}-Hydraulic Pump Litho in U.S.A. 10-13 1. Install new O-rings and plastic shields on piston plugs. IMPORTANT: To prevent damage to shields, DO NOT use an air-operated wrench to tighten piston plugs; use a torque wrench. 2. Install piston assemblies. For easier assembly, turn pump shaft so piston being installed is on the low side of cam. NOTE: Early design (recessed hex) piston plug torque specification is 136 N·m (100 Ib-ft). 1. Remove piston assemblies. (See Remove and Install Piston Assemblies in this group.) NOTE: Use vice grip with curved jaw for better clamping. 2.
Install vice grips as tightly as possible on pump shaft approximately 5/8 in. from housing hub. 3. Put a dial indicator base on pump housing and indicator contact point on steel ball placed in center of pump shaft. 4. Turn shaft back and forth while pushing down to align the tapered roller bearings inside pump housing. 3. Tighten piston plugs to 185 N·m (135 Ib-ft). INSTALL PISTON ASSEMBLIES CHECK SHAFT END PLAY AllTractorManuals.com