AW1;T85250,R39749,R39750 R70;070300 1082 150589 CTM-7 (5-89) 2R3; 010 15 110589 Single Bank Valve Double Bank Valve A-Valve Guide B-Dlscharge Valve C-Sprlng D-Dlscharge Valve Stop 2000 Series (PR)-Hydraulic Pump NOTE: Early design discharge valve assembly is shown at TOP of photograph and current design discharge valve assembly is shown at BOTTOM. Litho in U.S.A. 10-15 1. Remove pressure compensator housing on single bank pump or secondary housing with pressure compensator housing on double bank pump. (See Remove and Install Pressure Compensator Housing in this group.) IMPORTANT: Discharge valves must be Installed in their original bores. 2.
Remove discharge valves and put them in a parts tray to insure installation into the same bores from which they were removed. NOTE: Early design (non-serialized pump) discharge valve assembly is shown in TOP of photograph and current design (serialized pump) discharge valve assembly is shown in BOTTOM of photograph. 3. Inspect valve guide (A) for fatigue cracks at tabs and radius of legs. 5. Inspect springs (C) for excessive wear to coils and end surface of coils. Replace spring if wear is questionable. Single Bank-Early Design Free Length ..................... 13.5 mm (0.5 in.) (approximate) Test Length. ... . .. . ..... ......... ...... .. ... ..
12mm at 6-7 N (1.4-1.7 Ib force) Single Bank-Current Design and Non-Serialized Double Bank Free Length .................... 12.2 mm (0.48 in.) (approximate) Test Length ................................ 7.6 mm at 11-14 N (0.3 in at 2.5-3 Ib force) Serial Double Bank Free Length ..................... 40.6 mm (1.6 in.) (approximate) Test Length.............................. 29.7 mm at 39-48 N (1.2 in. at 9-11 Ib force) 6. Inspect valve (8) for erosion, pitting or excessive wear. Replace valve if wear is excessive. Discharge valve seat should also be checked for wear. (See Inspect, Remove, and Install Discharge Valve Seats in this group.) 7. Install discharge valves into their original bores.
SINGLE BANK PUMP-(Middle Photograph) DOUBLE BANK PUMp-{Bottom Photograph) REMOVE, INSPECT AND INSTALL DISCHARGE VALVES NEW SPRING SPECIFICATION 4. Inspect stop (D) for wear or damage. AllTractorManuals.com