R70;070300 1066 080288 AW1;R39785 R70;070300 1071 171287 AW1;R39758 R70;070300 1097 260489 CTM-7 (5-89) 2R3; 010 17 110589 2000 Series (PR)-Hydraulic Pump Litho in U.S.A. 10-17 IMPORTANT: Pistons must be installed in their original bores if they are reused. 1. Remove piston assemblies. (See Remove and Inspect Piston Assemblies in this group.) 2. Remove pressure compensator housing (and auxiliary gear-driven charge pump if so equipped on single bank pump) and secondary housing on double bank pump. (See Remove and Install Pressure Compensator Housing in this group.) IMPORTANT: Discharge valves must be Installed in their original bores. 3.
Remove discharge valve assemblies and put them in a parts tray. 4. Remove pump shaft on single bank pump using a hammer to remove bearing cup. Lift shaft from primary housing on double bank pump. 5. Replace oil seal (and quad ring and backup ring on non-serialized pumps) before installing pump shaft. (See Remove and Install Oil Seal-Pump Disassembled in this group.) 6. Install pump shaft in primary housing using JDG494 Spline Protector to prevent seal damage. NOTE: Install bearing cup on single bank pump leaving cup partially away from bearing cone. Installation of shims and pressure compensator housing will prop- erly align bearing cup and cone.
REMOVE AND INSTALL PUMP SHAFT AllTractorManuals.com