John Deere Radial Piston Pumps (3000 Series) — John Deere Radial Piston Pumps (3000 Series) User Manual

AW1;R39748,R3849b,R3994b R70;070300 1077 290188 CTM-7 (5-89) 2Rl; 010 19 11051119 2000 Series (PR)-Hydraulic Pump 10-19 For SINGLE BANK PUMP, perform Steps 7, 8, 9,10, 11, 12, and 13. NOTE: Non-serialized 65 cm3 (4 in. 3) pump shaft assembly (TOP photograph) using bronze thrust washers should be updated to design shown in MIDDLE photograph. Kits are available. 8. Inspect bearing (A) shoulder surface. Replace if spacer wear exists. NOTE: Some serialized pumps use a double row of needle rollers with a spacer between and on the ends of the rollers as shown in the BOTTOM photograph.) 9. Inspect spacers (B). Replace if worn. scored. or discolored. NOTE:

Refer to specifications for shaft journal 00. Most shafts will not have a lubrication hole in center of journal. 10. Inspect pump shaft journal (C). Replace if pitted. scored. or discolored. NOTE: "VESPEL @ thrust washers on serialized pump (bot- tom photograph) may require magnification for inspection. 11. Inspect thrust washers (D). Replace if worn or damaged. NOTE: Refer to specifications for needle roller 00 and race 00 and 10. 13. Inspect needle rollers (F). Replace ALL needle rollers if any are scratched. pitted or discolored. A-Bearing B-Spacers C-Pump Shaft D- Thrust Washers E-Race F-Needle Rollers 12. Inspect race (E). Replace if scored or discolored.

·VESPEL ® is a trademark of the DuPont Corporation. 7. Disassemble pump shaft. Litho in U.S.A. AllTractorManuals.com