Sea Water Pump C8.3 Industrial Page 6-14 Section 6 - Maintenance Procedures at 300 Hours or 1 Year Remove the inlet and outlet hose and drain the water from the pump. Remove CAUTION If the impeller has failed and pieces are missing, all pieces must be retrieved. The engine heat exchanger, gear oil cooler, and sea water aftercooler (if equipped) must be flushed. Refer to the procedures for flushing these components in other headings of this section. Failure to do so can result in overheating and damage to engine can occur. Impeller debris can also drop into the inlet piping.
Make sure all debris is removed before installing a new impeller; otherwise, additional impeller failures or engine overheating will occur. Remove the capscrews. Lift off the cover. Use a small screwdriver to remove the o-ring (A). Use a small screwdriver to remove the inner cap (B). Clean the o-ring groove.