Cummins — 4021330

C8.3 Industrial Sea Water Pump Section 6 - Maintenance Procedures at 300 Hours or 1 Year Page 6-15 Do not pry against the pump housing to remove the impeller as this can cause damage to the liner. CAUTION Be sure to note the direction of impeller fins for proper re- installation. Mark the outer surface. An impeller removal tool is available from Sherwood Pumps, Part Number 23631. If the impeller is equipped with a threaded insert, use the special tool or a ѕ-NFT bolt (1) to insert in the impeller to pull the impeller out. Be sure to note the direction of impeller fins for proper re- installation. Mark the outer surface.

If the impeller does not have a threaded bore, grasp the hub of the impeller with pliers and remove the impeller from the impeller bore. Clean and Inspect for Reuse Inspect for damage such as rips, tears, chunks of material missing, or wear on the edges of the blades. Replace as necessary. Clean the internal pump surfaces. Lubricate the housing with silicone or glycerine non- petroleum-based lubricant. Petroleum-based lubricant will damage the rubber impeller. If non-petroleum-based lubricant is not readily available, use soapy water to ease installation.