AGS (Code GE1), instructions for testing and repair work 29.10.2003 TR AGS (Code GE1), instructions for testing and repair work 102 Prior to depressurization the hydraulic pump plug connection on the transmission must be disconnected. After depressurization the plug connection must remain disconnected, otherwise the pressure will build up again when the ignition is switched on. The mechanical pressure limiting valve should be undone by half a revolution. If the mechanical pressure limiting valve is opened too far, there is a risk of draining the hydraulic system. The actuation may lead to fault entries in the control unit. These should be deleted at the end of the test.
Gear and clutch actuations and manual gearshifts can cause damage if the transmission unit is removed. Work may only be carried out on the hydraulic system if the system has been depressurized. No measurements may be taken on the contacts on the inside of the automatic gear control AGS control unit. Follow the instructions of the menu item "Control system – depressurization" 10/03 Trucks • Transmission Telligent automatic transmission in ACTROS and ATEGO > Specialist training Instructions for testing and repair work on the AGS gearshift system: Switch engine off. Secure the vehicle against rolling away and apply the parking brake. Depressurization (only hydraulic system operations):
Depressurization (installation and removal of the unit): Please note: Important: