Inspect for Intake Leaks Inspect Engine for Exhaust Leaks z Visually inspect the intake manifold, throttle assembly (D), and manifold adapters (E), for looseness and leaks. Repair as necessary. (D) Throttle Assembly (E) Manifold Adapter (F) TMAP Sensor Inspect Throttle Assembly z Start the engine and allow it to reach operating temperatures. z Repair any/all leaks found. Replace Oxygen Sensor 1. Stop engine and wait until the exhaust pipe and exhaust pipe is cooled. 2. Disconnect the electrical connector of oxygen sensor. 3. Remove oxygen sensor. 4. Assemble new oxygen sensor. Tightening torque : 45 N•m (32.5 lb•ft) 5. Connect the electrical connector of oxygen sensor.
z Perform visual inspection of exhaust system. D F E z Visually inspect the throttle assembly motor housing for coking, cracks and missing cover- retaining clips. Repair and/or replace as necessary. NOTE Refer to the LP mixer and throttle section of the service manual for procedures on removing the mixer and inspecting the throttle plate. Checking the TMAP Sensor z Verify that the TMAP sensor (F) is mounted tightly into the manifold adapter (E), with no leakage. z If the TMAP is found to be loose, remove the TMAP retaining screw and the TMAP sensor from the manifold adapter. z Visually inspect the TMAP O-ring seal for damage. Replace as necessary.
z Apply a thin coat of an approved silicon lubricant to the TMAP o-ring seal. z Re-install the TMAP sensor into the manifold adapter and securely tighten the retaining screw. G420E/G424E Tier LP Engine Maintenance Schedule 34