Table a.
MI-04 Diagnostic Fault Codes (Flash Codes) G420E/G424E Tier LP Engine Advanced Diagnostics 56 DFC Probable Fault Action Corrective Action, First Check 56 XDRPSensorInputHigh +5VDC Transducer power supplied by the SECM to the sensors is above +5.20VDC Engine Shutdown Measure transducer power at the TMAP connector with a multimeter TMAP PIN 3 +5VDC to TMAP PIN 1 XDCR GND Verify transducer power at the SECM with a multimeter SECM PIN 18 +5VDC to SECM PIN 1 XDCR GND Verify transducer power at ETC with a multimeter ETC PIN 3 XDCR PWR to ETC PIN 2 XDCR GND Verify transducer power to the Acceleration Pedal with a multimeter 57 Engine OverSpeed Engine RPM increased beyond maximum RPM set point Engine Shutdown Usually associated with additional ETC faults z Check for ETC Sticking or other ETC faults z Verify if the lift truck was motored down a steep grade 61 Pedal1SensorInputLo APP1 signal disconnected, open circuit or sensor malfunction (Expected faults when APP connector is unplugged CODES:
61 & 66) MIN Power Limit Check Acceleration Pedal connector z Check APP1 signal at SECM PIN 15 62 Pedal1SensorInputHi APP1 sensor failure or shorted circuit MIN Power limit Check Acceleration Pedal connector z Check APP1 signal at SECM PIN 15 63 Pedal1SensorRangeLo APP1 potentiometer malfunction. Improper APP1 reading may be due to dirt or oxidation on the sensor traces. Stored Fault Code (MIL Only) Check Acceleration Pedal connector z Cycle the pedal several times and check APP1 signal at SECM PIN 15 64 Pedal1SensorRangeHi APP1 potentiometer malfunction.
Improper APP1 reading may be due to dirt or oxidation on the sensor traces Stored Fault Code (MIL Only) Check Acceleration Pedal connector z Cycle the pedal several times and check APP1 signal at SECM PIN 15