John Deere K Series Air-Cooled Engines — CHECK CRANKSHAFT ALIGNMENT (TIR)

Cylinder Block, Valves and Internal Components/Crankshaft CHECK CRANKSHAFT ALIGNMENT (TIR) Place crankshaft into an alignment jig and rotate crankshaft slowly. Use dial indicators (A) to measure maximum total indicated runout (TIR). If not according to specification replace crankshaft. M80380 -UN-06APR91 M80381 -UN-06APR91 SPECIFICATIONS Maximum TIR . . . . . . . . . . . . . . . . . . . . . . . . . 0.05 mm (0.002 in.) FG150G FG150D CTM5 (20OCT92) 25-20-17 K Series Air Cooled Engine MX,2520A1,A27 -19-21OCT92 AllTractorManuals.com 220596 PN=174 INSPECT CRANKSHAFT BALL BEARINGS—FG150D 1. Remove oil seals. (See Inspect Oil Seals in this group.) -UN-29AUG88 2.

Remove crankshaft bearings using a bearing, bushing and seal driver set. 3. Thoroughly clean bearings in solvent. Dip bearings in light weight oil. M38073 4. Spin each bearing by hand and check for axial (A) and radial (B) free play. 5. Replace bearings if noisy or too much play. 6. Install bearings flush to inside of crankcase cover or cylinder block using a bearing, bushing and seal driver set. 7. Install oil seals. MX,2520A1,A26 -19-21OCT92 25 20 17