John Deere K Series Air-Cooled Engines — INSPECT CYLINDER BLOCK

Cylinder Block, Valves and Internal Components/Cylinder Block INSPECT CYLINDER BLOCK 1. Remove crankshaft. (See this group.) 2. Clean and check block for cracks. 3. Cracks not visible to the eye may be detected by coating the suspected area with a mixture of 25 percent kerosene and 75 percent light engine oil. 4. Wipe area dry and immediately apply coating of zinc oxide dissolved in wood alcohol. If crack is present, coating becomes discolored at the defective area. Replace block if any cracks are found. MX,2520A1,A29 -19-21OCT92 CTM5 (20OCT92) 25-20-18 K Series Air Cooled Engine AllTractorManuals.com 220596 PN=175 INSPECT OIL SEALS NOTE:

FG150G PTO is driven by the camshaft, FG150D PTO is driven by the crankshaft. 1. Remove flywheel. (See Group 10.) -UN-02APR91 2. Inspect oil seals (A and B) at flywheel end and PTO end for wear or damage. Replace if necessary. 3. Remove crankshaft. (See this group.) M80382 4. Remove worn or damaged seals with a screwdriver. Flywheel Side 5. Install seals with lip to inside of engine using bearing, bushing and seal driver set. Press seals in until flush with hub. 6. Install crankshaft. -UN-02APR91 7. Install flywheel. M80383 PTO Side—FG150G Shown MX,2520A1,A28 -19-21OCT92 25 20 18