Cylinder Block and Internal Components/Piston Rings REMOVE AND INSTALL PISTON RINGS 1. Remove piston rings with a piston ring expander. 2. Inspect piston. Clean piston ring grooves. (See this group.) M38074 -UN-29AUG88 3. Check piston ring end gap. (See this group.) 4. Install top ring (A) and second ring (B) with R or NPR mark facing up. Rings should turn freely in grooves. NOTE: Oil ring assembly is located near bottom of piston. A—Top Ring B—Second Ring 5. Oil ring is an assembly. Install spacer (C), then side C—Spacer rails (D). Put side rail end gaps 180˚ apart.
D—Side Rails MX,3020A1,A16 -19-21OCT92 CTM5 (20OCT92) 30-20-8 K Series Air Cooled Engine AllTractorManuals.com 220596 PN=213 INSPECT CONNECTING ROD 1. Clean and inspect rod. Replace if scored. 2. Analyze crankshaft and connecting rod wear. (See Section 100, Group 10.) -UN-31AUG88 3. Install connecting rod cap. Tighten to 12 N·m (106 lb-in.). 4. Measure connecting rod crankshaft bearing and piston M50066 bearing (A). Replace connecting rod if either measurement is greater than specifications. BEARING I.D. SPECIFICATIONS (MAX) Crankshaft Piston Bearing Bearing 28.07 mm 15.05 mm (1.105 in.) (0.593 in.) MX,3020A1,A15 -19-21OCT92 30 20 8