Cylinder Block and Internal Components/Crankshaft CHECK PISTON RING END GAP 1. Before installing rings on piston, check end gap in cylinder bore. 2. Install each ring squarely in bore approximately 25.4 mm (1.0 in.) down from top of cylinder. M80182 -UN-11FEB91 3. Check end gap. Replace ring if end gap is more than specifications. END GAP SPECIFICATIONS Minimum End Gap . . . . . . . . . . . . . . . . . . . . . 0.18 mm (0.007 in.) Maximum End Gap Compression Rings . . . . . . . . . . . . . . . . . . . 1.00 mm (0.039 in.) Oil Ring Side Rails . . . . . . . . . . . . . . . . . . . .
1.50 mm (0.059 in.) MX,3020A1,A17 -19-21OCT92 CTM5 (20OCT92) 30-20-9 K Series Air Cooled Engine AllTractorManuals.com 220596 PN=214 REMOVE, INSPECT AND INSTALL CRANKSHAFT 1. Remove camshaft. (See this group.) 2. Remove piston and connecting rod. (See this group.) -UN-11FEB91 3. Remove crankshaft. IMPORTANT: A bent crankshaft must be replaced; it cannot be straightened. M80183 4. Check crankshaft alignment (T.I.R.). (See this group.) 5. Clean and inspect crankshaft. Replace if parts are scratched or damaged. 6. Analyze crankshaft and connecting rod wear. (See Section 100, Group 10.) 7. Measure crankshaft main bearing journals and connecting rod journal.
Replace crankshaft if measurements are less than specifications. JOURNAL SPECIFICATIONS (MIN) Main Bearing Journal Connecting PTO Side Flywheel Rod Journal Side 24.92 mm 24.92 mm 27.92 mm (0.981 in.) (0.981 in.) (1.099 in.) MX,3020A1,A18 -19-21OCT92 30 20 9