Cylinder Block and Internal Components/Crankshaft CHECK CRANKSHAFT ALIGNMENT (TIR) Place crankshaft into an alignment jig and rotate crankshaft slowly. Use dial indicators (A) to measure maximum total indicated runout (TIR). If not according to specification replace crankshaft. M51761 -UN-07SEP88 SPECIFICATIONS TIR (Max) . . . . . . . . . . . . . . . . . . . . . . . . . . . 0.20 mm (0.008 in.) MX,3020A1,A21 -19-21OCT92 MEASURE CRANKSHAFT END PLAY 1. Measure end play using dial indicator (A). Record this measurement. 2. Move crankshaft in and out. Replace block or crankshaft if end play is not within specifications. M30048 -UN-06SEP88 SPECIFICATIONS End Play . . . . . . . . . . . . . . . . .
. . . . . . 0—0.50 mm (0—0.020 in.) CTM5 (20OCT92) 30-20-11 K Series Air Cooled Engine MX,3020A1,A22 -19-21OCT92 AllTractorManuals.com 220596 PN=216 INSPECT CRANKSHAFT BALL BEARING 1. Remove flywheel end oil seal. (See Inspect Oil Seals in this group.) 2. Remove crankshaft bearing using a bearing, bushing -UN-29AUG88 and seal driver set. 3. Thoroughly clean bearing in solvent. Dip bearing in light weight oil. M38073 4. Spin the bearing by hand and check for axial (A) and radial (B) free play. 5. Replace the bearing if it is noisy or has too much play. 6. Install bearing flush to inside of crankcase using a bearing, bushing and seal driver set. 7. Install oil seal.
MX,3020A1,A20 -19-21OCT92 30 20 11