John Deere K Series Air-Cooled Engines — INSPECT CYLINDER BLOCK

Cylinder Block and Internal Components/Inspect INSPECT CYLINDER BLOCK 1. Remove crankshaft. (See this group.) 2. Clean and check block for cracks. 3. Cracks not visible to the eye may be detected by coating the suspected area with a mixture of 25 percent kerosene and 75 percent light engine oil. 4. Wipe area dry and immediately apply coating of zinc oxide dissolved in wood alcohol. If crack is present, coating becomes discolored at the defective area. Replace block if any cracks are found. MX,3020A1,A24 -19-21OCT92 CTM5 (20OCT92) 30-20-12 K Series Air Cooled Engine AllTractorManuals.com 220596 PN=217 INSPECT OIL SEALS 1. Remove flywheel. (See Group 10.) 2.

Inspect oil seals (A and B) at flywheel end and PTO end for wear or damage. Replace if necessary. -UN-11FEB91 3. Remove crankshaft. (See this group.) 4. Remove worn or damaged seals with a screwdriver. M80185 5. Install seals with lip to inside of engine using a bearing, bushing and seal driver set. Press seals in until Flywheel End flush with hub. 6. Install crankshaft. 7. Install flywheel. -UN-11FEB91 M80186 PTO End MX,3020A1,A23 -19-21OCT92 30 20 12