Cylinder Block, Valves and Internal Components/Recondition Valve Seats INSPECT VALVE GUIDES Clean inside of valve guides with valve guide cleaner. Measure inside diameter of valve guides. Replace cylinder block if inside diameters are greater than specifications. (See this group.) M80460 -UN-17MAY91 SPECIFICATIONS (MAX) I.D. Intake Valve Guide . . . . . . . . . . . . . . . . . . . . . 8.00 mm (0.315 in.) Exhaust Valve Guide . . . . . . . . . . . . . . . . . . . . 8.08 mm (0.318 in.) MX,3520A1,A5 -19-21OCT92 CTM5 (20OCT92) 35-20-3 K Series Air Cooled Engine AllTractorManuals.com 220596 PN=248 RECONDITION VALVE SEATS 1. Inspect valve seats for damage.
If seats are loose, warped or distorted beyond reconditioning, replace cylinder head. Pitted or worn seats can be refaced using a seat cutter. -UN-31AUG88 2. To recondition valve seat, cut a 45˚ angle (B) to clean up seat. Cut narrowing angle (E) at 30˚. Finish cut at 45˚ (B) to establish seating surface width (A). M51558 3. Cut valve seating surface (A) as close as possible to specifications. 4. Lap valves to seats after refacing. (See Section 100, Group 05.) SPECIFICATIONS -UN-01SEP88 A—Valve Seating Surface . . . . . . . . . . . . . . . . 1.30 mm (0.050 in.) B—Valve Seat Angle . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 45˚ C—Valve Face Angle . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . 45˚ D—Valve Margin . . . . . . . . . . . . . . . . . . . . . . . 0.60 mm (0.020 in.) E—Valve Narrowing Angle . . . . . . . . . . . . . . . . . . . . . . . . . . . 30˚ M9552 MX,3520A1,A6 -19-21OCT92 35 20 3