John Deere K Series Air-Cooled Engines — DISASSEMBLE, INSPECT AND ASSEMBLE PISTON AND CONNECTING ROD

Cylinder Block, Valves and Internal Components/Piston and Connecting Rod DISASSEMBLE, INSPECT AND ASSEMBLE PISTON AND CONNECTING ROD 1. Remove circlip, piston pin (B) and connecting rod (A). 2. Inspect all parts for wear or damage. Replace as necessary. (See procedures in this group.) M80468 -UN-17MAY91 3. Apply a light film of oil to piston pin and connecting rod bearing. MX,3520A1,A19 -19-21OCT92 CTM5 (20OCT92) 35-20-11 K Series Air Cooled Engine AllTractorManuals.com 220596 PN=256 8. Deglaze cylinder bore. (See Section 100, Group 15.) 9. Align piston assembly to cylinder bore wth piston ring end gaps as shown. 10. Apply a light film of oil to piston and rings.

Compress -UN-31AUG88 rings with a ring compressor. 11. Apply a light film of oil to cylinder bore, connecting rod bearing surface and cap screws. M51529 12. Install piston assembly in cylinder bore with “R” on piston head facing flywheel side. 13. Align marks (D) on connecting rod and cap. Install connecting rod cap, oil splasher and lock plate. Tighten cap screws to specifications. 14. Bend locking tabs over cap screws. -UN-17MAY91 15. Install crankcase cover. 16. Install cylinder head. M80467 SPECIFICATIONS. Cap Screw Torque . . . . . . . . . . . . . . . . . . . . . .

21 N·m (186 lb-in.) A—First Ring End Gap B—Second Ring End Gap C—Oil Ring End Gap D—Alignment Marks MX,3520A1,A18 -19-21OCT92 35 20 11