Cylinder Block and Internal Components/Reciprocating Balancer CTM5 (20OCT92) 40-20-8 K Series Air Cooled Engine AllTractorManuals.com 220596 PN=319 DISASSEMBLE AND ASSEMBLE RECIPROCATING BALANCER NOTE: On FC290V engine, spacer (H) is governor drive gear. 1. Remove collar (A), gear (G) key (F) and gear or spacer (H). 2. Remove rods (B) and crankshaft (I). 3. Inspect crankshaft. (See this group.) 4. Inspect balancer assembly. (See this group.) 5. Put a light film of oil on bearing surfaces. NOTE: Oil grooves of link rods (B) must face away from crankwebs. -UN-07SEP88 6. Install balance weight to crankshaft with oil hole (E), if equipped, facing flywheel side. 7. Install collar (A). M51759 8.
Install gear or spacer (H) with chamfered face toward link rod. 9. Install key and crank gear. A—Collar B—Link Rod C—Wrist Pin D—Balance Weight E—Oil Hole F—Woodruff Key G—Crank Gear H—Spacer or Gear I—Crankshaft MX,4020A1,A12 -19-21OCT92 40 20 8