Cylinder Block and Internal Components/Reciprocating Balancer CTM5 (20OCT92) 40-20-9 K Series Air Cooled Engine AllTractorManuals.com 220596 PN=320 INSPECT BALANCER ASSEMBLY 1. Clean and inspect all parts for wear or damage. Replace parts, if necessary. 2. Measure crankshaft journals (A). Replace crankshaft if diameter is less than specifications. 3. Measure inside diameter of bearings (B). Replace link rod if small end is greater than specifications. Replace bushing if large end is greater than specifications. (See this group.) NOTE: FC290V engine is not equipped with a replaceable support shaft bushing. If bearing is worn, replace weight. 4.
Measure inside diameter of support shaft bearing (C). If bearing is greater than specifications, replace bushing, if equipped. (See this group.) -UN-07SEP88 5. Measure support shaft diameter (D). Replace shaft if diameter is less than specification. 6. Inspect wrist pins (E) for any damage. If necessary, M51760 replace weight. DIAMETER SPECIFICATIONS Link Rod Journal O.D. (MIN) A—Link Rod Journals FC290V . . . . . . . . . . . . . . . . . . . . . . . . . . 46.86 mm (1.845 in.) B—Link Rod Bearings FC400V/FC420V . . . . . . . . . . . . . . . . . . . . 53.95 mm (2.124 in.) C—Shaft Bearing FC540V . . . . . . . . . . . . . . . . . . . . . . . . . .
57.94 mm (2.281 in.) D—Support Shaft Link Rod Small End I.D. (MAX) E—Wrist Pins All . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 12.06 mm (0.475 in.) Link Rod Large End I.D. (MAX) FC290V . . . . . . . . . . . . . . . . . . . . . . . . . . 47.12 mm (1.855 in.) FC400V/FC420V . . . . . . . . . . . . . . . . . . . . 54.12 mm (2.131 in.) FC540V . . . . . . . . . . . . . . . . . . . . . . . . . . 58.15 mm (2.289 in.) Support Shaft O.D. (MIN) All . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 25.93 mm (1.021 in.) Support Shaft Bearing I.D. (MAX) All . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 26.10 mm (1.027 in.) MX,4020A1,A13 -19-21OCT92 40 20 9