John Deere K Series Air-Cooled Engines — DISASSEMBLE, INSPECT AND ASSEMBLE PISTON AND CONNECTING ROD

Cylinder Block and Internal Components/Piston and Connecting Rod 8. Deglaze cylinder bore. (See Section 100, Group 15.) 9. Stagger piston ring end gaps 180˚ apart, but do not align with oil ring side rail end gaps. 10. Apply a light film of oil to piston and rings. Compress rings with a ring compressor. M50074 -UN-31AUG88 11. Apply a light film of oil to cylinder bore, connecting rod bearing surface and cap screws. 12. Install piston assembly in cylinder bore with engraved match mark/arrow on piston head facing flywheel side of engine. 13. Install connecting rod cap and cap screws. Tighten cap screws to specifications. 14. Rotate governor shaft and tighten nut. 15. Install crankcase cover.

16. Install cylinder head. TORQUE SPECIFICATIONS Connecting Rod Cap Screws . . . . . . . . . . . . . . . 20 N·m (177 lb-in.) MX,4520A1,A13 -19-21OCT92 CTM5 (20OCT92) 45-20-9 K Series Air Cooled Engine AllTractorManuals.com 220596 PN=390 DISASSEMBLE, INSPECT AND ASSEMBLE PISTON AND CONNECTING ROD 1. Remove circlip, piston pin (A) and connecting rod (B). 2. Inspect all parts for wear or damage. Replace as -UN-31AUG88 necessary. (See procedures in this group.) 3. Apply a light film of oil to piston pin and connecting rod bearing. M50063 MX,4520A1,A14 -19-21OCT92 45 20 9