Cylinder Block and Internal Components/Piston Rings INSPECT CONNECTING ROD 1. Clean and inspect rod. Replace if scored. 2. Analyze crankshaft and connecting rod wear. (See Section 100, Group 10.) M50066 -UN-31AUG88 3. Install connecting rod cap. Tighten to 20 N·m (177 lb-in.). 4. Measure connecting rod crankshaft bearing and piston bearing (A). Replace connecting rod if either measurement is greater than specifications. BEARING I.D. SPECIFICATIONS (MAX) Crankshaft Bearing Piston Bearing 35.57 mm (1.400 in.) . . . . . . . . . . . . . . . . . .
19.06 mm (0.750 in.) MX,4520A1,A19 -19-21OCT92 CTM5 (20OCT92) 45-20-12 K Series Air Cooled Engine AllTractorManuals.com 220596 PN=393 REMOVE AND INSTALL PISTON RINGS 1. Remove piston rings with a piston ring expander. 2. Inspect piston. Clean piston ring grooves. (See this group.) -UN-08MAY91 3. Check piston ring end gap. (See this group.) 4. Install top ring (A) and second ring (B) with R or NPR mark facing up. Rings should turn freely in grooves. M80429 5. Oil ring is an assembly. Install spacer (C), then side rails (D). Put side rail end gaps 180˚ apart. A—Top Ring B—Second Ring C—Spacer D—Side Rails MX,4520A1,A20 -19-21OCT92 45 20 12