John Deere K Series Air-Cooled Engines — CHECK PISTON RING END GAP

Cylinder Block and Internal Components/Piston Rings CHECK PISTON RING END GAP 1. Before installing rings on piston, check end gap in cylinder bore. 2. Install each ring squarely in bore approximately 25.4 mm (1.0 in.) down from top of cylinder. M80430 -UN-25APR91 3. Check end gap. Replace ring if end gap is more than specifications. END GAP SPECIFICATIONS Minimum End Gap . . . . . . . . . . . . . . . . . . . . . 0.18 mm (0.007 in.) Maximum End Gap Compression Rings . . . . . . . . . . . . . . . . . . . 1.20 mm (0.047 in.) Oil Ring Side Rails . . . . . . . . . . . . . . . . . . . . . . . .

Not Measured MX,4520A1,A21 -19-21OCT92 45 20 13 CTM5 (20OCT92) 45-20-13 K Series Air Cooled Engine AllTractorManuals.com 220596 PN=394