Cylinder Block and Internal Components/Crankshaft INSPECT CRANKSHAFT BALL BEARING 1. Remove crankcase cover and oil seal. (See Inspect Oil Seals in this group.) 2. Remove crankshaft bearing using a bearing, bushing and seal driver set. M38073 -UN-29AUG88 3. Thoroughly clean bearing in solvent. Dip bearing in light weight oil. 4. Spin the bearing by hand and check for axial (A) and radial (B) free play. 5. Replace the bearing if it is noisy or has too much play. 6. Install bearing flush to inside of crankcase cover using a bearing, bushing and seal driver set. 7. Install oil seal. 8. Install crankcase cover.
MX,4520A1,A25 -19-21OCT92 CTM5 (20OCT92) 45-20-16 K Series Air Cooled Engine AllTractorManuals.com 220596 PN=397 CHECK CRANKSHAFT ALIGNMENT (TIR) Place crankshaft into an alignment jig and rotate crankshaft slowly. Use dial indicators (A) to measure maximum total indicated runout (TIR). If not according to specification replace crankshaft. -UN-08MAY91 SPECIFICATIONS Maximum TIR . . . . . . . . . . . . . . . . . . . . . . . . . 0.05 mm (0.002 in.) M80432 MX,4520A1,A26 -19-21OCT92 45 20 16 MEASURE CRANKSHAFT END PLAY 1. Measure end play using dial indicator (A). Record this measurement. 2. Move crankshaft in and out.
Remove crankcase cover -UN-25APR91 and adjust end play if not within specifications. (See this group.) SPECIFICATIONS M80433 End Play . . . . . . . . . . . . . . . . . . 0.09—0.22 mm (0.004—0.009 in.) MX,4520A1,A27 -19-21OCT92