John Deere K Series Air-Cooled Engines — BENCH TEST SOLENOID DRIVE STARTER

Starting Systems/Electric Starter CTM5 (20OCT92) 45-30-4 K Series Air Cooled Engine AllTractorManuals.com 220596 PN=411 BENCH TEST SOLENOID DRIVE STARTER NOTE: Perform bench test before disassembling starter motor to determine cause of problem. IMPORTANT: Never operate motor longer than 20 seconds. Allow at least two minutes for cooling and battery recovery before operating again. Overheating, caused by excessive operation, will seriously damage starting motor. 1. Disconnect battery leads from battery. 2. Remove starter from engine. 3. Connect 12-volt battery (A) to starter battery terminal (B) and starter frame (C) using heavy duty cables. 4.

Connect remote start switch (D) between switch -UN-29AUG88 terminal (E) and battery terminal (B). NOTE: A short piece of wire with a small clip on the end will allow a more positive connection at the switch terminal. M37149 When switch is activated, starter should engage and run. IF SOLENOID CHATTERS; hold-in winding is A—12-Volt Battery open-circuited. B—Battery Terminal C—Starter Frame IF NOTHING HAPPENS; either the solenoid pull-in D—Remote Start Switch winding is open-circuited or mechanical parts are E—Switch Terminal sticking. IF SOLENOID ENGAGES, BUT MOTOR DOES NOT RUN; check solenoid switch continuity, brushes, armature and field windings. Solenoid cannot be repaired, replace it.

MX,4530A1,A5 -19-21OCT92 45 30 4