John Deere K Series Air-Cooled Engines — CHECK PISTON RING END GAP

Cylinder Block, Valves and Internal Components/Piston Rings REMOVE AND INSTALL PISTON RINGS 1. Remove piston rings with a piston ring expander. 2. Inspect piston. Clean piston ring grooves. (See this group.) M38074 -UN-29AUG88 3. Check piston ring end gap. (See this group.) 4. Install top ring (A) and second ring (B) with R or NPR mark facing up. Rings should turn freely in grooves. 5. Oil ring is an assembly. Install spacer (C), then side rails (D). Put side rail end gaps 180˚ apart. A—Top Ring B—Second Ring C—Spacer D—Side Rails MX,5020A1,A28 -19-21OCT92 CHECK PISTON RING END GAP 1. Before installing rings on piston, check end gap in cylinder bore. 2.

Install each ring squarely in bore approximately 25.4 mm (1.0 in.) down from top of cylinder. M54788 -UN-19FEB91 3. Check end gap. Replace ring if end gap is more than specifications. END GAP SPECIFICATIONS (MAX) Minimum End Gap . . . . . . . . . . . . . . . . . . . . . 0.18 mm (0.007 in.) Maximum End Gap Compression Rings . . . . . . . . . . . . . . . . . . . 0.70 mm (0.028 in.) Oil Ring Side Rails . . . . . . . . . . . . . . . . . . . . 1.20 mm (0.047 in.) MX,5020A1,A29 -19-21OCT92 50 20 17 CTM5 (20OCT92) 50-20-17 K Series Air Cooled Engine AllTractorManuals.com 220596 PN=448