Cylinder Block, Valves and Internal Components/Crankshaft CHECK CRANKSHAFT ALIGNMENT (TIR) Place crankshaft into an alignment jig and rotate crankshaft slowly. Use dial indicators (A) to measure maximum total indicated runout (TIR). If not according to specification replace crankshaft. M51761 -UN-07SEP88 SPECIFICATIONS Maximum TIR . . . . . . . . . . . . . . . . . . . . . . . . . 0.05 mm (0.002 in.) MX,2020A1,A28 -19-21OCT92 MEASURE CRANKSHAFT END PLAY 1. Measure end play using dial indicator (A). 2. Move crankshaft in and out. Record this measurement. Replace block or crankshaft if end play is not within specifications. M80264 -UN-19MAR91 SPECIFICATIONS End Play . . . . . . . . . . . . . .
. . . . . . . . . 0—0.30 mm (0—0.012 in.) CTM5 (20OCT92) 20-20-17 K Series Air Cooled Engine MX,2020A1,A29 -19-21OCT92 AllTractorManuals.com 220596 PN=78 INSPECT CRANKSHAFT BALL BEARING 1. Remove PTO end oil seal. (See Inspect Oil Seals in this group.) 2. Remove crankshaft bearing from crankcase cover -UN-29AUG88 using a bearing, bushing and seal driver set. 3. Thoroughly clean bearing in solvent. Dip bearing in light weight oil. M38073 4. Spin the bearing by hand and check for axial (A) and radial (B) free play. 5. Replace the bearing if it is noisy or has too much play. 6. Install bearing flush to inside of crankcase cover using a bearing, bushing and seal driver set. 7. Install oil seal.
MX,2020A1,A27 -19-21OCT92 20 20 17