Cylinder Block, Valves and Internal Components/Inspect INSPECT CYLINDER BLOCK 1. Remove crankshaft. (See this group.) 2. Clean and check block for cracks. 3. Cracks not visible to the eye may be detected by coating the suspected area with a mixture of 25 percent kerosene and 75 percent light engine oil. 4. Wipe area dry and immediately apply coating of zinc oxide dissolved in wood alcohol. If crack is present, coating becomes discolored at the defective area. Replace block if any cracks are found. CTM5 (20OCT92) 20-20-18 K Series Air Cooled Engine MX,2020A1,A31 -19-21OCT92 AllTractorManuals.com 220596 PN=79 INSPECT OIL SEALS NOTE: Pack lithium base grease in new or used seals. 1.
Remove flywheel. (See Group 10.) -UN-11MAR91 2. Inspect oil seals (A and B) at flywheel end and PTO end for wear or damage. Replace if necessary. 3. Remove crankshaft. (See this group.) M80265 4. Remove worn or damaged seals with a screwdriver. Flywheel Side 5. Install seals with lip to inside of engine using a bushing, bearing and seal driver set. Press in seal on flywheel side until flush with hub. Press in PTO side seal below crankcase cover flange -UN-11MAR91 surface, to specification. 6. Install crankshaft. 7. Install flywheel. M80266 SPECIFICATIONS PTO Side Seal Depth . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 mm (0.150 in.) MX,2020A1,A30 -19-21OCT92 20 20 18